Flooring Contractor in El Paso, TX - Floors Prepped to Last in the Heat

Possibly, because the city's building permit rules cover altering or repairing a building, and they don't single out floor coatings either way. Changing how a space is used also needs a permit, so a garage turned into a gym or a shop can need one even when the coating itself is simple. We check with the One Stop Shop for your address before we start.

It comes down to your floor, so I'll give you a written number after I've looked at it. The big factors are size, how much crack and pit repair the slab needs, whether an old coating has to come off, and the system you pick, since a flake or metallic finish with a polyaspartic topcoat costs more than a basic epoxy coat. A slab with moisture problems can need extra work too, and that's better found at the estimate than halfway through the job.

Most peeling starts with prep, when coating goes over a slab that wasn't ground open, was holding moisture or had an old finish that was already letting go. Heat adds to it, since hot tires can lift a thin or poorly bonded coat, and the humid summer storm months can make some products harder to install well. We grind, test and repair before anything goes down, and if you're collecting bids, ask every installer how they prep, not just what they put on top.

For a garage that sits open to afternoon sun, I lean toward an epoxy base with a polyaspartic topcoat, because plain epoxy can yellow in sunlight and polyaspartic holds its color better. The trade-off is that polyaspartic cures fast, so there's less working time and the prep has to be right the first time. In a garage that stays closed and shaded, a good epoxy system on its own is often fine, and I'll tell you which I'd pick once I've seen yours.

The City of El Paso publishes its own list of currently adopted codes, built on the International Building Code and International Residential Code with local amendments in the city code. The city code also has its own chapters for electrical, plumbing, pool and spa, and energy work. On a floor job that usually matters when the project goes past the floor, like new walls or wiring in a converted garage.

Usually not, because a new coating only holds as well as the layer under it, and old paint or epoxy that's already lifting will take the new coat with it. We grind or strip the old finish down to sound concrete, and a coating nobody can name is exactly the kind of floor I like working out. Sometimes a well-bonded older coat can be ground and recoated, and I'll tell you which you have once I've tested it.